NE555 pulse frequency, duty ratio adjustable module / square wave signal generator

€2.49
Tax included *
19 items
Quantity

 

100% confiance. Vos achats et données sont totalement sécurisés.

 

Envoi le jour même si commande validé avant 11h30.

 

Politique retours 14 jours.

First, this module Scope:
1 is used as a square wave signal generator generates a square wave signal for experimental development to use.
2 is used to generate drive stepper motor drives a square wave signal.
3 adjustable pulse generation for MCU to use.
4 generates an adjustable pulse, the control-related circuit.
Second, a brief description:
1, Size: 3.1CM * 2.2CM
1, the main chip: NE555;
2, the input voltage: 5V-15VDC. 5V supply, the output current can be about 15MA; when 12V power supply, the output current can be about 35MA;
 
3, the input current: ≥100MA
4, the output amplitude:. 4.2V V-PP to 11.4V V-PP (different depending on the input voltage, the output amplitude will be different)
5, the maximum output current: ≥15MA (5V supply, V-PP greater than 50%), ≥35MA (12V power supply, V-PP greater than 50%)
 
 
Three Advantages:
1, the output with LED indication, there is no output straightforward (low level LED quantity, high LED off, LED blinks when the frequency is low);
2, grade selectable output frequency range, the output frequency is more continuously adjustable;
LF file: 1Hz ~ 50Hz
IF file: 50Hz ~ 1kHz
High frequency gear: 1KHz ~ 10kHz
High frequency profile: 10kHz ~ 200kHz
 
3, the output duty cycle can be fine-tuning, duty cycle and frequency are not separately adjustable, adjusting the duty cycle will change the frequency;
4, the output frequency is adjustable;
Cycle T = 0.7 (RA + 2RB) C
 
RA, RB for 0-10K adjustable;
 
At low frequencies stalls C = 0.001UF;
IF stalls when C = 0.1UF;
High-frequency gear C = 1UF;
When high-frequency gear C = 100UF, therefore frequency waveform buyers can own calculations.

1581Z
19 Items