Shop By Categories

Diodes

New products

X5 Connection cables for 4-Pin LED Strip RGB 5050 10mm

€3.99
Tax included *
Quantity

  • 100% confiance. Vos achats et données sont totalement sécurisés. 100% confiance. Vos achats et données sont totalement sécurisés.
  • Envoi le jour même si commande validé avant 11h30. Envoi le jour même si commande validé avant 11h30.
  • Politique retours 14 jours. Politique retours 14 jours.

Compatible with waterproof and non-waterproof SMD RGB 5050 single color LED strips.
1.Make sure your LED strip is 10mm wide and has 4 contacts (+, B, R and G).
2. Open the white connector clasp
3.If you use a non-waterproof SMD5050 RGB LED strip (no silicon on the surface), simply insert the LED light strip into the clasp of this cable, under the pins. Be sure to match the 4 pins of the LED strip with the connector.
If you are using a waterproof SMD5050 RGB LED strip (with silicon on the surface of the led strip), you must first peel the silicon off the surface around the solder / cut area, then insert the LED strip. match the 4 pins of the LED strip with the connector.
4. Close the connector.
pull on the LED strip to confirm that you have made a solid connection.

Additional function:
If you need to connect your tape to a drive or power supply, you can cut a connector to solder that cable to your drive or power supply.

Important note:
If the connection is loose, the LEDs blink or do not light. To ensure good connection and good electrical conductivity, follow this trick:
After inserting the LED strip into the connector, before closing the connector cap, pull slightly and press the LED strip to adjust the connection point until the LEDs light up. If the LEDs do not light up, use your finger to press a little on the 4 metal contacts of the connector, until the LEDs come on.

CONDITIONING:
X5 Connection cables for 4-Pin LED Strip RGB 5050 10mm

4210Z
2 Items